Support
box-sousmenu-top
box-sousmenu-bottom
Remote controls

HDA-IR2.2

HDA-IR2.2
Zoom Zoom
Remote control for Standard Digital Terminal.

Help

The remote was originally programmed to control the DTA terminal only. It can however also be configured to control most TVs. To proceed, follow the instructions below:

How to program your remote with a Code
  1. Turn on your TV

  2. Press simultaneously on PROG and TV, hold until the DEL button of the remote lights up.

  3. Enter the TV manufacturer’s CODE.

    • If the CODE is valid, DEL will switch off

    • If the CODE is invalid, the DEL will flash twice. Try entering the code again or input another.

  4. Test the TV button to see if it turns the television on or off.
How to search for a code
  1. Turn on the television
  2. Press simultaneously on PROG and TV and hold until the DEL on the remote lights up.
  3. Press the TV button once to launch the automatic search mode. The DEL will light up with each new code tested. If needed, press CH+ to continue with the next code, or «CH-» to try the previous one.
  4. Press Prog when the television turns off in order to save the code.
Volume control

Before setting the volume control on the television, adjust it on the set top box. Make sure the volume is set to MAX, as it won’t be possible to adjust it afterwards.

 

How to control the volume using your set top box:

  1. Press simultaneously on PROG and TV until the DEL on the remote lights up.
  2. Press the «vol-» button.

How to control the volume using your television:

  1. Press simultaneously on PROG and TV, hold until the DEL on the remote lights up
  2. Press the «vol+» button
How to reset your remote
  1. Press simultaneously on PROG, DTA and ENTER , hold for 2 seconds
  2. The LED will flash twich to confirm the reset.
Has this article answered your questions?
Yes
No

Need help? Contact Technical Support
Customer service
Services for the
hearing impaired (TTY)
1-877-380-2611
From your Videotron mobile phone, dial 611.
24/7